Sizing Made Easy (Rings, Bracelets, & Tees)

Sizing Made Easy (Rings, Bracelets, & Tees)

Dec 31, 2025Carolina Fojo

Ring Sizing

If you’ve never worn rings and don’t know where to start, I recommend buying a ring sizer to figure out your size. Here’s one you can buy and return after measuring all your pretty piggies. (FYI: Amazon affiliate link).

The width of the ring band changes the size you need. This is the most common mistake I see—many people know their thin band ring size, but a wide band may require sizing up a full size (or more).

For example, a smaller ring will fit true to size, but for a wide band, I usually recommend sizing up one full size. I always include ring size guidance on each product page under “Size/Fit.”

The reason for sizing up is simple: fingers taper at the base, and most rings sit at that point. A wider band hits the bulge between your finger base and bottom knuckle, making it tighter. Wide bands also have less flexibility going over your knuckle.

Here’s a hack I use for wide bands:

1. Start with your thin band size (I’m a 6.5 in the example below).

2. Stack rings from the ring sizer, increasing in size until the width you want fits comfortably. You can see in the photo the 6.5 no longer fits when stacked with others. 

3. Make sure to try it in both directions (the smallest size towards the bottom, then towards the top) and move your finger to check comfort. In my case, a 7 fit, but a 7.5 felt best.


For thick and wide rings, give yourself at least a half size of wiggle room. Fingers swell throughout the day and seasons, so it’s easier to go slightly larger than too small.

If the ring is wide on top but tapers underneath, you won’t need to size up as much—the taper gives space for the finger bulge. In that case, I only size up ½ instead of a full size.

Image Features Semilla de Frida Ring

 


Bracelet Sizing

Bangles

Bangles are a full, enclosed circle, so your hand has to fit through the smallest point. 

Image features Southwestern Stamped Bangle

Measure with a tape or a strip of paper and a ruler: wrap around your hand, mark where it meets, then measure the length.

Cuffs

Cuffs have an opening (usually 1–1.5”) and slide on from the side of your wrist. Measure your wrist circumference where you plan to wear the cuff.

Bulkier cuffs or ones with large stones sit higher on your arm than thin ones. I prefer chunkier cuffs to sit above my wrist knuckles.

Image features Gothic Onyx Druzy Cuff.

Check the product page for sizing details:

  • For a loose, moveable fit, order the same size as your wrist.

  • For a snug fit, order ½ inch smaller than your wrist measurement.

Tee Sizing

Last but not least– tee sizing. First up– I put detailed sizing info on every product page, so please check out the “Size/Fit” section with measurements to get the clearest picture of sizing! 

That said, here are some general tips. While I personally don’t gender any of my clothing, I source from vendors who do. So if you’re familiar with “Women’s Clothing” vs. “Men’s Clothing”, this might help: 

  • Crop tops are generally assumed to be for women only (I know, it’s dumb), so if you’re buying a crop, assume that they’re sized that way.

  • Basic Tees are supposed to be for all genders (“unisex”), but my personal experience has been that I (femme body) can buy my typical size (Medium), while some of my masc bodied friends have needed to size up. Keep in mind that this also depends on how baggy you want a tee to be, and the fact that many of the tees are not pre-shrunk. 

If you have any questions, you can reach me directly at strawberrylightningllc@gmail.com.

 



More articles